Key points for sprinkler installation
1. Protect the faucet and other hardware
When tightening the faucet, the careful person will wrap the screw cap of the faucet with thick cloth or plastic film to prevent the faucet from being scratched by the wrench.
2. Pay attention to cleaning after installation
It is inevitable that some ash and dirt will be generated during the installation process, which should be cleaned after the installation is completed. In particular, there are many impurities in the newly decorated pipeline, and the water outlet effect will be affected if the pipeline is not cleaned. Ensure that the site is clean and can be washed with water.
3. Determine the installation height of sprinkler
When determining the installation height of the shower, the installer shall determine the most appropriate height according to the trial situation of the owner on site, so as to facilitate the owner's use in the future.
4. Determine the hole spacing and height of cold and hot water
Generally, the distance between the cold and hot water center holes of the shower faucet on the market is 15 cm, and there will be two s joints inside. The distance can be adjusted appropriately, and the error cannot exceed 1 cm.

Precautions for sprinkler installation
1. When installing the shower, it is necessary to drill holes. When drilling, it should be noted that the water pipe in the wall cannot be penetrated;
2. When installing the round bottom cover of the shower, be sure to tighten the screws, otherwise the shower will fall off;
3. When installing the hand-held shower, it shall not be robbed or distorted;
4. Before installing the shower, the installation height must be determined and marked.